| DESIGN OF AN AIR-COOLED CONDENSER FOR ENGINE COOLANT WASTE HEAT RECOVERY |
| S. J. BAE1, H. S. HEO2, C. J. KIM3, H. Y. LEE4 |
1Korea Automotive Technology Institute
2KATECH
3Seoul National University
4Doowon Climate Control Co.LTD. |
|
|
|
|
|
| ABSTRACT |
|
A novel design process for a parallel multi-flow type air-cooled condenser of a dual-loop waste heat recovery system with Rankine steam cycles, for improving the fuel efficiency of gasoline automobiles, has been investigated, focusing on reduction of the pressure drop inside the micro-tubes. The low temperature condenser plays a role in dissipating heat from the system, by sufficiently condensing the low temperature loop working fluid. However, the refrigerant has low enough evaporation temperature to recover the waste heat from engine coolant of about 100oC, but has small saturation enthalpy, so that excessive mass flow rate of the LT working fluid, e.g. over 150 g/s, causes an enormously large pressure drop of the working fluid, to maintain the heat dissipation performance of more than 20 kW. This paper has dealt with a scheme to design a low temperature condenser that has reduced the pressure drop, while ensuring the required thermal performance from the waste heat recovery system. The number of passes, arrangement of the tubes of each pass, and positions of the inlet and outlet pipes on the header are the most critical parameters affecting flow uniformity through all the tubes of the condenser. For the purpose of the performance predictions and parametric study for the LT condenser, we have developed a 1-dimensional userfriendly performance prediction program that feasibly calculates the phase change of the working fluid in the tubes. The proposed design process enables design engineers to find the optimum values of the numbers of passes and tubes of the multiflow condenser, for the reduction of the pressure drop sustaining the heat exchange performance. An example is presented through the proposed design process, and compared with an experiment. |
| Key Words:
Waste heat recovery system, Rankine steam cycle, Parallel multi-flow condenser, Pressure drop, Flow uniformity, Heat dissipation |
|
|
|
Preview
Full text via DOI
Download Citation 
Print 
